호프 허브 중 어느 모델인지 알려주셔야죠. Hope 홈페이지 가보시면 분해도와 메뉴얼 있습니다.
http://www.hopetech.com/database/xc_hub%2Bcass_ass_explo%2Btab.jpg
http://www.hopetech.com/database/Rear_Cassette_hub_inst.PDF

바이스 플라이어로 헝겁(기스 방지용)을 대고 물려서 다른 방향으로 분해하시면 되신답니다^^

일자드라이버로 스페이서를 빼면 됩니다. 축과 꽉 끼게 설계되있어서 흠집 않네고 빼기는 힘들것 같네요.

Remove wheel and unscrew lock-ring holding sprockets in position, withdraw sprockets. Use a broad blade screw-driver to prise out the spacer (item 12) from inside the rotor (item 8). Remove rotor body (item 8), turning anti-clockwise at the same time so as to prevent pawls being dislodged. Remove pawls and springs and clean with meths or white spirit to remove old grease. Wipe out old grease from inside ratchet. Do not immerse hub in degreaser, as this will remove grease from bearings.

Assembly Procedure:
Smear a thin layer of grease around pawl locations in rotor body and ratchet in hub. Insert springs into body, carefully re-place pawls into seatings. (The grease will help to retain them). Make sure springs are located properly in pawl and body. Slide rotor body assembly onto spindle. Using a small screw-driver, ease pawls into ratchet whilst applying a gentle pressure to end of rotor body. When fully engaged rotor should spin freely in an anti-clockwise direction with the pawls clicking lightly and evenly. The rotor should lock up immediately when turned clockwise. Replace spacer (item 12) with ‘0’ ring installed. Apply a light film of grease to rotor splines and clean sprockets and refit. Replace sprocket retainer ring and tighten to required torque 40 Nm (30 ft.lb.).

NOTE: If all steel sprockets are used slight marking of the rotor body may occur but this will not impair the function of the product It is not recommended for HOPE hubs to be built radially.

그부분은 손으로 댕기면 빠집니다..
그다음 베어링이나 라쳇부분은 저도 분해를 해보질 않아서..

제것은 그냥 않빠지던데요, 스페이서만 빼면 로터바디는 따로 잡아주는 것이 없어서 그냥 빠지게 되어있습니다.